MSDS Document
Product Dynatex® 49594 White Lithium Grease
1. Chemical Product and Company Identification
Trade Name of this Product Dynatex® 49594 White Lithium Grease

Phone Number
Emergency Phone
Revision Date
2. Composition and Information on Ingredients
CAS Number
3. Hazard Identification
Chronic Effects of Overexposure
Exposure to vapors generated at high temperatures may cause respiratory irritation. Not
regarded as health hazard under current legislation.
Existing Conditions Aggravated by Exposure
No known applicable information.
4. First Aid Information
Eye Contact
Immediately flush eyes with water for at least 15 minutes. Get medical attention if irritation
Page 2 5Print Rev. Date 08/28/2009MSDS ID DYN49594Dynatex® 49594 White LithiumGrease Skin Contact
In case of contact with skin immediately remove contaminated clothing. Wash thoroughly
with soap and water. Wash contaminated clothing before reuse.
Vapor inhalation under ambient conditions is normally not a problem. If overcome by vapor
from hot product, immediately remove from exposure and seek medical attention. If
breathing has stopped, start resuscitation; administer oxygen if breathing is irregular. If
overexposed to oil, remove from further exposure until excessive mist conditions subside.
DO NOT INDUCE VOMITING. Seek immediate medical attention.
5. Fire Fighting Measures
Flash Point
FP Method
Extinguishing Media
Use carbon dioxide (CO2). Dry chemicals, sand dolomite, etc. Alcohol resistant foam, water
spray, fog or mist.
Special Fire Fighting Procedures
Use water to keep fire-exposed containers cool and disperse vapors. Water spray may be
used to flush spills away from exposure and to dilute spills to non-flammable mixtures.
Avoid water if straight hose stream: will scatter and spread fire. Keep run-off out of sewers
and water sources. Dike for water control.
Unusual Fire and Explosion Hazards
Pressure will increase in over-heated, closed containers.
Hazardous Combustion Products
Oxides of carbon
Protective Measures in Case of Fire
Self-contained breathing equipment and chemical resistant clothing.
6. Accidental Release Measures
Steps to be taken in case of spill or release
Keep product out of sewers and watercourses by diking or impounding. Advise authorities
if product has entered or may enter sewers, watercourses or extensive land areas. Assure
conformity with applicable government regulations. Minimize skin contact with spilled
product. Spilled material, unused contents and empty containers must be disposed of in
accordance with local, state and federal regulations.
Page 3 5Print Rev. Date 08/28/2009MSDS ID DYN49594Dynatex® 49594 White LithiumGrease 7. Handling and Storage
Ventilate well, avoid breathing vapors. Use approved respirator if air contamination is above
accepted level. Avoid spilling, skin and eye contact. Eye wash and emergency shower must
be available at the work place.
Keep away heat, sparks, and open flame. Do not reuse container. Keep lid closed when not
in use. Do not store or mix with strong oxidizers.
8. Exposure Controls and Personal Protection
Exposure Limit For Product
5 mg/m3 for oil mist (aerosol) for an 8-hour workday.
Basis: Regulation 29 CFR 1910.1000 and recommended by the American Conference ofGovernmental Industrial Hygienists (ACGIH). ACGIH states that sir is to be sampled by amethod that does not collect vapor; in addition, it lists a 10 mg/m3 STEL.
Normally not needed under ordinary conditions. No smoking or use of flame or other
ignition sources.
Respiratory Protection
Normally not needed. Use supplied air respiratory protection in confined or enclosed
spaces if needed.
Eye Protection
Use splash goggles or face shield when eye contact may occur.
Skin Protection
Use chemical resistant gloves, if needed, to avoid prolonged or repeated skin contact.
Other Protective Equipment
Use chemical-resistant apron or other impervious clothing, if needed, to avoid contaminating
regular clothing, which could result in prolonged or repeated skin exposure.
9. Physical and Chemical Properties
Specific Gravity
Melting/Freezing Point
Evaporation Rate
Vapor Density
The above information is not intended for use in preparing product specifications. Contact
Page 4 5Print Rev. Date 08/28/2009MSDS ID DYN49594Dynatex® 49594 White LithiumGrease Accumetric LLC before writing specifications.
10. Stability and Reactivity
Normally stable
Hazardous Polymerization
Will not occur
Conditions to Avoid
Avoid contact with acids and oxidizing substances.
Hazardous Decomposition Products
Carbon oxides
11. Toxicological Information
Special Hazard Information on Components
No known applicable information.
Component Toxicology Information
No known applicable information.
12. Ecological Information
Environmental Fate and Distribution
Complete information is not yet available.
Environmental Effects
Complete information is not yet available.
Fate and Effects in Waste Water Treatment Plants
Complete information is not yet available.
13. Disposal Considerations
Waste Disposal Method
We make no guarantee or warranty of any kind that the use or disposal of this product
complies with all local, state, or federal laws. It is also the obligation of each user of the
product mentioned herein to determine and comply with the requirements of all applicable
This product is not known to be regulated under RCRA regulations. Disposal of unusedportions of this product and process waste containing this product should be done onlyafter a careful evaluation and in compliance with all federal, local and state laws.
Page 5 5Print Rev. Date 08/28/2009MSDS ID DYN49594Dynatex® 49594 White LithiumGrease 14. Transportation Information
DOT Road Shipment Information
Not subject to DOT.
15. Regulatory Information
The contents of this MSDS comply with the OSHA Hazard Communication Standard 29 CFR1910.1200.
TSCA Status
All chemical substances found in this product comply with the Toxic Substances Control Act
inventory reporting requirements.
SARA Title III Section 302 Extremely Hazardous Substances
SARA Title III Section 304 CERCLA Hazardous Substances
SARA Title III Section 313 Toxic Chemicals
None present or none present in regulated quantities.
California Proposition 65
This product contains the following chemical(s) listed by the State of California under the
Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65) as being known to
cause cancer, birth defects or other reproductive harm:
None known
16. Other Information
The data contained herein is based upon information that Accumetric LLC believes to be
reliable. Users of this product have the responsibility to determine that suitability of use and
to adopt all necessary precautions to ensure the safety and protection of property and
persons involved in said use. All statements to suggestions are made without warranty,
expressed or implied, regarding the accuracy of the information, the hazards connected with
the use of the material or the results to be obtained from the use thereof.


Kapitel 6: arzneimittelkommission der deutschen Ärzteschaft (tätigkeitsbericht 2010 der bundesärztekammer)

Arzneimittelkommission der deutschen Ärzteschaft Kapitel 6. Arzneimittelkommission der deutschen Ärzteschaft 6.1 Aufgaben Die Arzneimittelkommission der deutschen Ärzteschaft (AkdÄ) berät seit 1952 als wis-senschaftlicher Fachausschuss der Bundesärztekammer (BÄK) diese in allen Fragen derArzneibehandlung und Arzneimittelsicherheit. Sie dient in gleicher Funktion der Kas-senärztlic

_____brett l. schmidli

BRETT L. SCHMIDLI INDUSTRIAL EXPERIENCE Beckman Coulter, Inc. Vice President, Discovery & Lab Automation Supply Chain Management 8/09 to Present Vice President, Immunoassay Manufacturing Operations 6/07 to 8/09 I lead the High Sensitivity Testing (HST) Group supply chains for our Immunoassay, Manual Immunoassay, and Molecular Diagnostics businesses. This in

© 2010-2017 Pharmacy Pills Pdf